Continuous Forms Eject Mode; Manual Paper Overlay - IBM 3 User Manual

Continuous Forms Eject Mode

You can set Continuous Forms Eject Mode value to:
v Immediate Eject (Default)
v Delayed Eject
Selecting Delayed Eject causes the printer to wait until the end of the current page
is reached before forms are moved to the tear off position. For more information,
see "Load/Eject" on page 47.
To change or check Continuous Forms Eject Mode:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for Continuous Forms Eject
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Manual Paper Overlay

You can set manual paper overlay to one of the following values:
Disabled (Default)
Enabled
Notes:
1. If Manual Paper Overlay is set to Enabled, when loading a cut-sheet form into
2. The Manual Paper Overlay function can be used only with the front push
3. An overlaying manual sheet can be loaded into the printer only when the
To change or check the Manual Paper Overlay value:
1. Press Menu.
152
4247 Model 003 User's Guide
CONFIGURATION MENU
Printer Setup
Printer Setup
Continuous Forms Eject Mode
Mode is displayed.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
Defines Manual Sheet Feed and tractor paper feeding simultaneously as
disabled.
Defines Manual Sheet Feed and tractor paper feeding simultaneously as
enabled.
the printer, hold the form firmly in place until the form is fed into the printer.
forms path.
printer is in a not ready state.