1. Press Test.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter. The printer displays the following:
6. Press Enter. The printer will now tune the sensors. Once the sensors are tuned,
7. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
Quit From Menu
This selection cancels any changes that have been made to the Printer Adjustment
parameter values in the Operator Print Test menu. All previous printer adjustment
values are restored when this parameter is selected and the printer enter the Not
Ready state.
Note: Quit From Menu is available only in the Operator Print Tests menu.
To quit from the Operator Print Test menu and restore the previous values for
Printer Adjustments only, follow these steps:
1. Press Scroll or Scroll until the printer displays
2. Press Enter. The printer displays
3. Press Enter. The printer restores the previous values and becomes not ready.
4247 OPERATOR PRINT TESTS
Printer Adjustments
Printer Adjustments
Sensor Tune
Sensor Tune
Clear ALL Paths and Press ENTER
the printer displays
Sensor Tune
Sensor Tune Complete
Printer Adjustments
Sensor Tune
on page 55.
Printer Adjustments
Quit from Menu
Quit from Menu
Restore Previous Values
Chapter 11. Printer Adjustments
173