IBM 3 User Manual page 243

18. Move the spacers along the tractor bar to support the width of the form.
19. Close the forms guide and the top cover.
Top Cover
Forms Guide
20. Press Load/Eject to feed the forms.
In the Dual-Push mode, two different forms can be in the printer; one continuous
form in the Rear-Push forms path, and one continuous form in the Front-Push
forms path. Either form can be loaded and printed, however, the other form must
be parked. See "Parking One Continuous Form and Loading Another" on page 234.
If your applications do not control forms settings (such as Characters Per Inch,
Lines Per Inch, or Maximum Print Position [MPP]), and you do not want to use
the printer default settings, see Chapter 3, "Checking and Changing Configuration
Parameter Values".
To return to the Front Push position:
v Press Park/Path to park the Rear-Push path forms.
v Press Park/Path again to back the forms below the print line.
v Press Park/Path a third time to change the forms path to Front.
233
Chapter 17. Setting Up Forms Paths