The front forms-tractor and rear forms-tractors are interchangeable. Either forms
tractor can be used in either location after you have set it for the forms path you
have selected.
Setting Up Front Push Forms Path (Default)
Figure 6 shows the Front Push forms path with the Manual Sheet Feed forms path.
Figure 6. Front Push Forms Path (with Manual Sheet Feed)
Setting Front Push Tractor
The Front Push forms tractor should be set to position (2), as shown in Figure 7 on
page 15.
If the tractor is set to position (1), perform the following:
1. Hold the tractor face-down with the electrical connector tab on the right side,
2. Pull the bottom release levers toward you with your finger tips and push the
14
4247 Printer Model A00 User's Guide
and pointing toward you.
movable edge of the tractor down toward the flat surface with your thumbs or
the palms of your hands (position 2).