Graphics Print Direction; Perforation Safety - IBM 3 User Manual

4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for bar code print direction is
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Graphics Print Direction

You can set the Graphics Print Direction to:
Unidirectional (Default)
Bidirectional
To change or check the graphics print direction, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for graphics print direction is
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Perforation Safety

You can set perforation safety to either of the following values:
Disabled (Default)
Printer Setup
Bar Code Print Direction
displayed.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
Causes the printer to print in only one direction, either from left to right or
from right to left, for each of the two passes of graphics printing on a line.
Causes the printer to print as the printhead moves in both directions. (This
setting causes faster throughput but may affect print quality. Verify that the
print quality is acceptable before running a print job.)
CONFIGURATION MENU
Printer Setup
Printer Setup
Graphics Print Direction
displayed.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
The printhead is not parked all the way to the right of the print line while
the perforation of the form is passing through the mylar opening.
155
Chapter 10. Printer Setup