IBM 3 User Manual page 320

1. Open the manual cut-sheet door in the front of the printer by pulling down at
2. Inspect the area for paper. Remove all the paper that you find. Use puffs of air
3. To test the cleaning, press Stop. If the 099 message remains, try removing paper
Corrective Action 2
099 message during a Park operation
The Park operation, initiated with the Park/Path key and 091 FANFOLD PARK...
message, requires that any fanfold forms above the tear bar be torn off before
confirming the Park operation with a second press of Park/Path. Failure to tear off
forms may result in the 099 message indicating that the forms have has backed up
a certain distance but were not detected as being back on the tractor.
1. Press Stop once. The 099 message will change back to the 091 FANFOLD PARK
2. Press Stop a second time. The 099 message remains on the display but the
3. Open the top cover.
4. Tear off at any form perforation above the carriage/printhead.
5. Close the top cover.
6. Press Park/Path once. The park operation will restart. If the 099 message
The attachment card that is installed in the printer is not compatible with the base
printer microcode.
Recovery:
Printer base microcode must be downloaded for the installed attachment. Call for
service.
No attachment card was found during power-on.
Recovery:
1. If the attachment card was removed, and the attachment card cover plate is in
310
4247 Model 003 User's Guide
the center thumb-slot below the 'V' mark on the cabinet.
to blow any pieces of paper or chad away from the sensor. This sensor is
located above the black patch.
from above the black patch again.
... message.
alarm will stop.
returns, the forms have been backed up a certain distance but the printer again
did not detect that the forms are back on the tractor. Repeat the steps for
Corrective Action 2. If the path has been successfully cleared, the forms will be
parked.
200 ATTACHMENT INCOMPATIBLE
SEE USER'S GUIDE
201 NO ATTACHMENT CARD FOUND
SEE USER'S GUIDE
place (covering the attachment card slot at the rear of the printer), confirm this
by pressing Start. The operator panel displays the default READY Parallel.
Recovery was successful.