Lines Per Inch (Lpi) - IBM 3 User Manual

4. Press Scroll or Scroll until the printer displays
Parallel Configuration
Override Host
5. Press Enter, and the printer displays
Parallel Configuration
Paper Source
6. Press Scroll or Scroll until the printer plays
Parallel Configuration
Characters Per Inch
7. Press Enter to display the current value.
8. Press Scroll or Scroll until the desired value for Characters Per Inch is
displayed.
9. Press Enter to display the current value.
An asterisk (*) is displayed in front of the selected value.
10. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
on page 55.

Lines Per Inch (LPI)

This parameter allows the printer to accept or ignore (override) the Lines Per Inch
commands that are sent by the host data stream. You can set Lines Per Inch to:
Disabled (Default)
The printer accepts and processes commands received from the host data
stream for Lines Per Inch selection.
Enabled
The printer ignores commands received from the host data stream for
Characters Per Inch. The printer will use the Lines Per Inch value set in the
printer configuration.
To change or check the Lines Per Inch setting:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Parallel and Serial Configuration
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
Parallel Configuration
Override Host
5. Press Enter, and the printer displays
Parallel Configuration
Paper Source
Chapter 9. Parallel and Serial Configuration
133