IBM 3 User Manual page 307

Recovery: There are two forms of this message. They are distinguished by what
appears in the second line of the operator panel display, as follows:
PRESS LOAD
Auto Restore is set to Disabled and an Eject has moved the form up to the
Tear bar. The printer is waiting. This is most likely to occur during a tear
off operation. Tear the forms at the perforation at the tear bar. Then a
manual Restore must be done by pressing Load/Eject. If the Processor light
is blinking it means that the next job has already been received and is
pending.
(blank second line)
Auto Restore is set to Data or Timer and an Eject has moved the form up
to the Tear bar. The printer will restore the form automatically either when
the next job is received (Auto Restore = Data) or after a defined time
elapses (Auto Restore = Timer).
004 PRESS LOAD
Recovery:
1. Press Load/Eject to position the form to the top of form position and enable
printing.
005 MARGIN ERROR
ADJUST MARGIN OR LINE LENGTH
Recovery:
1. Press Stop.
The left margin automatically resets to 10 units. See Chapter 11, "Printer
Adjustments".
2. Press Start.
006 HOST REQUESTS ATTENTION
See your computer operator for further action.
Recovery:
1. Press Stop to stop the alarm from beeping.
007 INCORRECT PRINT ORDER
PRESS STOP THEN START
Recovery:
Notify the computer operator to check the data stream and then:
1. Press Stop.
2. Press Start.
3. Resubmit the print job.
008 HOLD PRINT TIMEOUT
PRESS STOP THEN START
297
Chapter 20. Problems