Automatic Eject - IBM 3 User Manual

If Automatic Restore = Data, once the form is at the tear bar it will remain there
until the next job is received by the printer at which time the printer will
automatically restore the forms back down to the print line and resume printing.
See the following tables for recommendations for Auto Eject and Auto Restore for
single-path and dual path uses.

Automatic Eject

This parameter is displayed for the Front Push or Rear Push forms path. You can
set the printer to perform an automatic eject without pressing Load/Eject when a
print job is complete.
You can set this value to:
Enabled
Disabled (Default)
To change or check the automatic eject after timeout, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
150
4247 Model 003 User's Guide
Table 16. Single Path Usage Recommendations
Operation No. Users
Single Path 1
Single Path 1
Single Path 2 or more
Single Path 2 or more
Note: The combination of settings with Automatic Eject = Enabled and Automatic Restore
= Disabled is not recommended.
Table 17. Dual Path Usage Recommendations
Operation No. Users
Dual Push 1
Dual Push 1
Dual Push 2 or more
Dual Push 2 or more
Note: The combination of settings with Automatic Eject = Enabled and Automatic Restore
= Disabled is not recommended.
When the print job is complete, the printer will perform an automatic eject
after a fixed timeout of approximately 5 seconds.
No automatic eject. The Load/Eject is required to eject the forms.
CONFIGURATION MENU
Printer Setup
Printer Setup
Automatic Eject
Tear Off Auto Eject
On Demand Disabled
Constant Enabled
On Demand Disabled
Constant Enabled
Tear Off Auto Eject
On Demand Disabled
Constant Enabled
On Demand Disabled
Constant Enabled
Auto Restore
Data or Timer
Data or Timer
Timer
Timer
Auto Restore
Data
Data
Data
Data