Coax Attachment - IBM 3 User Manual

READY
Twinax
Note: If the printer does not show the correct display sequence, go to the
status code section of Chapter 20, "Problem Solving" and follow the
instructions there for the status code shown on the display panel.

Coax Attachment

DANGER
<1-14> Switch off printer power and unplug the printer power cord before
connecting or disconnecting a communication port, a teleport, or any other
attachment connector.
DANGER
<1-13> Do not connect or disconnect a communication port, a teleport, or any
other connector during an electrical storm.
To attach a coax cable (not shipped with the printer), follow these steps:
1. The power switch is located on the lower left side of the printer. Ensure that
the printer is powered off (O) and the power cable is unplugged.
2. Attach one end of the signal cable to the upper interface connector on the back
of the printer.
3. Turn the signal cable connector clockwise until the cable locks in place.
4. Connect the power cord to the printer and to the electrical outlet.
5. Power on (|) the printer.
6. Wait until the message IBM 4247 appears, all segments of the LCD on the
operator panel display are lighted, and the printer has stopped all motion. The
printer then displays:
DIAGNOSTICS IN PROGRESS
PLEASE WAIT
READY
Coax
Note: If the printer does not show the correct display sequence, go to the
status code section of Chapter 20, "Problem Solving". and follow the
instructions there for the status code shown on the display panel.
<A>
Front
<A>
Front
Chapter 1. Getting Started
27