Form Feed Mode - IBM 3 User Manual

Disabled (Default)
Enabled
To change or check the Continuous Forms Linking:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for Continuous Forms Linking
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Form Feed Mode

You can set Form Feed Mode to either of the following values:
v Not Active In Ready State (Default)
v Active In Ready State
Selecting Active in Ready State makes the Form Feed key active when the printer
is ready and no job is processing, so that when pressed, a form feed will be
performed and the printer will return to the ready state.
The printer does not have to be not ready before pressing Form Feed if you change
the value to Active in the ready state.
To change or check the form feed mode:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
148
4247 Model 003 User's Guide
No linking is to be done.
The Front Push and Rear Push continuous forms paths are to be linked
together so they are treated by the printer as one continuous paper source.
CONFIGURATION MENU
Printer Setup
Printer Setup
Continuous Forms Linking
is displayed.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
CONFIGURATION MENU
Printer Setup
Printer Setup
Form Feed Mode