Asf Bin 1 Paper Load Position; Asf Bin 2 Automatic Forms Thickness Adjustment (Afta) - IBM 3 User Manual

8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
Note: If the ASF Bin 1 left margin alignment is too large for the current print line,

ASF Bin 1 Paper Load Position

This parameter adjusts the distance of the first printable line to the top of the
paper from -24 to +576 units (4 in.) (where each unit is 0.176 mm [1/144 in.]). The
default value is 0.
To change or check the ASF Bin 1 Paper Load Position:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for ASF Bin 1 Paper Load
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

ASF Bin 2 Automatic Forms Thickness Adjustment (AFTA)

This parameter allows you to adjust the distance between the paper and the
printhead when the ASF device is installed and the Paper Source parameter is set
to Bin 2. Paper must be loaded for this adjustment to be effective. This adjustment
can be set to one of the following values:
-5 to +3
Fixed 1 to 8
To change or check the ASF Bin 2 AFTA:
1. Press Menu.
166
4247 Model 003 User's Guide
on page 55.
an 005 MARGIN ERROR ADJUST MARGIN OR LINE LENGTH will occur. For more
information on the message, see Chapter 20, "Problem Solving" on page 295.
CONFIGURATION MENU
Printer Adjustments
Printer Adjustments

ASF Bin 1 Paper Load Position

Position is displayed.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
The printer automatically adjusts the distance between the paper and the
printhead. Each adjustment corresponds to 0.03 mm (.0012 in.). (The
default is 0, which corresponds to a gap of 0.25 mm [.01 in.] from the
paper.)
Selects a fixed printhead distance value from 1 to 8 (where each value
equals approximately 0.05 mm [.002 in.]).