Procedure - IBM 3 User Manual

It is not recommended to select Manual when the printer is set for either the
Rear-Pull or the Push-Pull forms paths. Manual can be selected from the operator
panel, but to use it, you will need to re-configure the paper path both before and
after using Manual. Manual cannot be selected via the IPDS data stream when the
printer is set for either the Rear Pull or the Push Pull forms paths.
Notes:
1. If you currently have the printer configured for the Rear Pull path, before using
2. If the printer is currently configured for the Rear Pull or Push-Pull forms paths,
3. If you are using the Manual Paper Overlay option, ensure you have the value

Procedure

1. Press Park/Path.
2. Press Stop and perform the action requested on the operator panel display.
3. Press Park/Path to back the forms below the print line.
4. Press Park/Path again to change the path on the operator panel display to
5. Insert your thumb into the center opening and pull the door down.
270
4247 Model 003 User's Guide
Manual Sheet Feed you must install the paper bail.
you must put the forms guide metal deflector in the push (open) position before
using the Manual Sheet Feed.
set to Enabled in the Printer Setup category, continuous forms are loaded in the
appropriate forms path, then continue with step 5.
An overlaying manual sheet can be loaded into the printer only when the
printer is in "not ready" state.
If continuous forms are currently in the printer for Front Push, Rear Push, or
Push-Pull, the printer displays
091 FANFOLD PARK
TEAR OFF AT OUTPUT AND PRESS PARK
If continuous forms are currently in the printer for Rear Pull, the printer
displays
092 FANFOLD PARK
TEAR OFF AT INPUT AND PRESS EJECT
Manual.