Using Programmed Symbols (Ps) Parameters; Plane Selection - IBM 3 User Manual

Enabled
To change or check the Override Host / Paper Source selection, follow these steps:
1. Press Menu.
2. Press Scroll
3. Press Enter.
4. Press Scroll
5. Press Enter and the printer displays
6. Press Enter to display the current value.
7. Press Scroll
8. Press Enter. An asterisk (*) will be displayed in front of the selected value.
9. Press Start or Return to exit the Menu.

Using Programmed Symbols (PS) Parameters

You can only define the following parameters if the Programmed Symbols (PS)
parameter in the Printer Compatibility category is set to Enabled. See
"Programmed Symbols" on page 109.
You can define the following PS Parameters:
v Plane Selection
v Full Page On Skip Suppress
v PS Print Direction

Plane Selection

You can set the Plane Selection to:
v 3 Single + 1 Triple (Default)
v 6 Single.
Note: The printer performs a partial reset to put any change to this parameter
To change or check the plane selection, follow these steps:
Allows the operator panel selection for paper source to override host data
stream commands for paper source selection.
or Scroll
CONFIGURATION MENU
Coax Configuration
or Scroll
Coax Configuration
Override Host
Override Host
Paper Source
or Scroll
Source is displayed.
value into effect when you exit the Configuration Menu with Start or
Return. Buffered data will be lost.
1. Press Menu.
until the printer displays
until the printer displays
until the desired value for Override Host / Paper
Chapter 8. Coax Configuration
113