To Set Autoscale Preferences - Agilent Technologies InfiniiVision 3000 X-Series User Manual

3 Press the Wait softkey; then, turn the Entry knob to select the number
4 Press the Preview softkey to preview the screen saver you have selected
5 To view the normal display after the screen saver has started, press any

To set AutoScale preferences

1 Press [Utility] > Options > Preferences > AutoScale.
2 In the AutoScale Preferences Menu, you can:
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
of minutes to wait before the selected screen saver activates.
When you turn the Entry knob, the number of minutes is displayed on
the Wait softkey. The default time is 180 minutes (3 hours).
with the Saver softkey.
key or turn any knob.
Press the Fast Debug softkey enable/disable this type of autoscale.
•
When fast debug is enabled, autoscale lets you make quick visual
comparisons to determine whether the signal being probed is a DC
voltage, ground, or an active AC signal.
Channel coupling is maintained to allow easy viewing of oscillating
signals.
Press the Channels softkey and turn the Entry knob to specify the
•
channels to be autoscaled:
All Channels — The next time you press [AutoScale], all channels that
•
meet the requirements of AutoScale will be displayed.
Only Displayed Channels — The next time you press [AutoScale], only
•
the channels that are turned on will be examined for signal
activity. This is useful if you only want to view specific active
channels after pressing [AutoScale].
Press the Acq Mode softkey and turn the Entry knob to select whether
•
the acquisition mode should be preserved during autoscale:
Normal — to make the oscilloscope switch to Normal acquisition
•
mode whenever the [AutoScale] key is pressed. This is the default
mode.
19
Utility Settings
263