3Com S7906E Command Reference Manual page 939

ipv6 route-static
Syntax
ipv6 route-static ipv6-address prefix-length [ interface-type interface-number ] nexthop-address
[ preference preference-value ]
undo ipv6 route-static
[ nexthop-address ] [ preference preference-value ]
View
System view
Default Level
2: System level
Parameters
ipv6-address prefix-length: IPv6 address and prefix length.
interface-type interface-number: Interface type and interface number of the output interface.
nexthop-address: Next hop IPv6 address.
preference-value: Route preference value, in the range of 1 to 255. The default is 60.
Description
Use the ipv6 route-static command to configure an IPv6 static route.
Use the undo ipv6 route-static command to remove an IPv6 static route.
An IPv6 static route that has the destination address configured as ::/0 (a prefix length of 0) is the
default IPv6 route. If the destination address of an IPv6 packet does not match any entry in the routing
table, this default route will be used to forward the packet.
Related commands: display ipv6 routing-table, delete ipv6 static-routes all.
Examples
# Configure a static IPv6 route, with the destination address being 1:1:2::/24 and next hop being
1:1:3::1.
<Sysname> system-view
[Sysname] ipv6 route-static 1:1:2:: 24 1:1:3::1
ipv6-address prefix-length
1-2
[ interface-type interface-number ]