Display Ospfv3 Vlink - 3Com S7906E Command Reference Manual

Metric
Next-Hop
Interface

display ospfv3 vlink

Syntax
display ospfv3 [ process-id ] vlink
View
Any view
Default Level
1: Monitor level
Parameters
process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.
Description
Use the display ospfv3 vlink command to display OSPFv3 virtual link information. If no process is
specified, virtual link information of all OSPFv3 processes is displayed.
Examples
# Display OSPFv3 virtual link information.
<Sysname> display ospfv3 vlink
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area :0.0.0.1 via interface Vlan-interface100, instance ID: 0
Local address: 2000:1::1
Remote address: 2001:1:1::1
Transmit Delay is 1 sec, State: P-To-P,
Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Retransmit: 5
Hello due in 00:00:02
Adjacency state :Full
Table 1-18 display ospfv3 vlink command output description
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area 0.0.0.1 via interface
Vlan-interface100
instance ID
Local address
Remote address
Field
Field
1-22
Description
Cost value
Next hop
Outbound interface
Description
The virtual link VLINK1 to router 1.1.1.1 is up
Interface Vlan-interface100 in transit area
0.0.0.1.
Instance ID
Local IPv6 address
Remote IPv6 address