Ospfv3 Peer - 3Com S7906E Command Reference Manual

View
Interface view
Default Level
2: System level
Parameters
broadcast: Specifies the network type as Broadcast.
nbma: Specifies the network type as NBMA.
p2mp: Specifies the network type as P2MP.
p2p: Specifies the network type as P2P.
non-broadcast: Specifies the interface to send packets in unicast mode. By default, an OSPFv3
interface whose network type is P2MP sends packets in multicast mode.
instance-id: The instance ID of an interface, in the range of 0 to 255, which defaults to 0.
Description
Use the ospfv3 network-type command to set the network type for an OSPFv3 interface.
Use the undo ospfv3 network-type command to restore the default.
By default, the network type of an interface depends on its link layer protocol. For example:
For PPP, the default network type is P2P.
For Ethernet, the default network type is broadcast.
Examples
# Configure the interface's network type as NBMA.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 network-type nbma

ospfv3 peer

Syntax
ospfv3 peer ipv6-address [ dr-priority dr-priority ] [ instance instance-id ]
undo ospfv3 peer ipv6-address [ instance instance-id ]
View
Interface view
Default Level
2: System level
Parameters
ipv6-address: Neighbor link-local IP address.
dr-priority: Neighbor DR priority, in the range 0 to 255. The default is 1.
instance-id: Interface instance ID, in the range 0 to 255. The default is 0.
1-31