Log-Peer-Change (Is-Is View) - 3Com S7906E Command Reference Manual

SNMP Trap is enabled by default.
Examples
# Enable SNMP Trap.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] is-snmp-traps enable

log-peer-change (IS-IS view)

Syntax
log-peer-change
undo log-peer-change
View
IS-IS view
Default Level
2: System level
Parameters
None
Description
Use the log-peer-change command to enable the logging of IS-IS neighbor state changes.
Use the undo log-peer-change command to disable the logging.
The logging is enabled by default.
After the logging is enabled, information about IS-IS adjacency state changes is sent to the
configuration terminal.
Examples
# Enable logging on the IS-IS adjacency state changes.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] log-peer-change
lsp-fragments-extend
Syntax
lsp-fragments-extend [ [ level-1 | level-2 | level-1-2 ] | [ mode-1 | mode-2 ] ] *
undo lsp-fragments-extend
View
IS-IS view
1-51