Isis Dis-Name - 3Com S7906E Command Reference Manual

Description
Use the isis cost command to set the IS-IS cost of an interface.
Use the undo isis cost command to restore the default.
No cost is configured by default.
If neither level-1 nor level-2 is included, the cost applies to both level-1 and level-2.
You are recommended to configure a proper IS-IS cost for each interface to guarantee correct route
calculation.
Relate command: circuit-cost.
Examples
# Configure the Level-2 IS-IS cost as 5 for VLAN-interface10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis cost 5 level-2

isis dis-name

Syntax
isis dis-name symbolic-name
undo isis dis-name
View
Interface view
Default Level
2: System level
Parameters
symbolic-name: Specifies a DIS name, a string of 1 to 64 characters.
Description
Use the isis dis-name command to configure a name for a DIS to represent the pseudo node on a
broadcast network.
Use the undo isis dis-name command to remove the configuration.
No name is configured for the DIS by default.
Note that this command takes effect only on a router that must have dynamic system ID to host name
mapping enabled. This command is not supported on a Point-to-Point interface.
This command is not available in loopback interface view.
1-39