Replacing the T640 Management Ethernet Cables
Copyright © 2010, Juniper Networks, Inc.
To replace the cables that connect to the ports, perform the procedures described in the
following topics:
Replacing the T640 Management Ethernet Cables on page 181
Replacing the T640 Console or Auxiliary Cable on page 183
Replacing the T640 Alarm Relay Wires on page 184
To replace the management Ethernet cables:
Press the tab on the connector and pull the connector straight out of the
1.
port. Figure 86 on page 182 shows the connector.
Disconnect the cable from the network device.
2.
Plug one end of the replacement cable into the appropriate
3.
labeled
HOST 0
connect to the Routing Engine in the upper Routing Engine slot (
and the ports labeled
HOST 1
Engine slot (
).
RE1
Plug the other end of the cable into the network device.
4.
Chapter 17: Replacing T640 Router Hardware Components
connect to the Routing Engine in the lower Routing
ETHERNET
port. The ports
ETHERNET
RE0
),
181