Tm31 Terminals" Default Setting - Siemens SINAMICS S150 Operating Instructions Manual

6.4.2

"TM31 terminals" default setting

Prerequisites
The "TM31 Terminals" default setting was chosen during commissioning:
• STARTER:
• AOP30:
Command sources
Figure 6-11
Priority
The priority of the command sources is shown in the diagram "Command sources - AOP30
←→ terminal TM31".
Note
The emergency OFF and motor protection signals are always active (regardless of the
command source).
For LOCAL master control, all of the supplementary setpoints are de-activated.
Drive converter cabinet units
Operating Instructions, 07/07, A5E00288214A
"TM31 Terminals"
"6: TM31 terminals
Command sources - AOP30 ←→ terminal TM31
Operation
6.4 Command sources
189