Siemens SINAMICS S150 Operating Instructions Manual page 335

Changing over the units
The units can be changed over via the AOP30 and via STARTER.
● Unit changeover via AOP30 is always carried out immediately. Once the corresponding
● If STARTER is used, unit changeover can only take place in offline mode in the
Unit groups
Each parameter that can be switched is assigned to a unit group which can be switched
within certain limits depending on the group.
This assignment and the units groups for each parameter appear in the parameter list in the
SINAMICS Parameter Manual.
The unit groups can be individually switched using 4 parameters (p0100, p0349, p0505 and
p0595).
Parameters
• p0010
• p0100
• p0349
• p0505
• p0595
• p0596
• p2000
• p2001
• p2002
• p2003
• p2004
• p2005
• p2007
Drive converter cabinet units
Operating Instructions, 07/07, A5E00288214A
parameters have been changed, the values affected are displayed in the new selected
unit.
configuration screen of the corresponding drive object. The new units are not displayed
until after the download ("Load project to target system") and subsequent upload ("Load
project to PG") have been completed.
Commissioning parameter filter
IEC/NEMA mot stds
Selection of units system, motor equivalent circuit diagram data
Selection of units system
Selection of technological unit
Reference variable of technological unit
Reference frequency/speed
Reference voltage
Reference current
Reference torque
Reference power
Reference angle
Reference acceleration
Functions, monitoring, and protective functions
9.3 Drive functions
335