Siemens SINAMICS S150 Operating Instructions Manual page 70

Electrical installation
4.9 Other connections
Commissioning
In the event of commissioning using the STARTER or AOP30, the sine-wave filter must be
activated by means of appropriate selection screenforms or dialog boxes, see the section
titled "Commissioning".
The following parameters are changed automatically during commissioning.
Table 4-20
Parameter
Note
When the factory settings are restored, parameter p0230 is reset.
The parameter must be reset if the system is commissioned again.
70
Parameter settings for sinusoidal filters with SINAMICS S150
p0233 Power module motor reactor
p0234 Power module sinusoidal filter
capacitance
p0290 Power module overload response
p1082 Maximum speed
p1800 Pulse frequency
p1802 Modulator mode
Name
Filter inductance
Filter capacitance
Disable pulse frequency reduction
Fmax filter / pole pair number
Nominal pulse frequency of the filter (see
previous table)
Space-vector modulation without
overmodulation
Setting
Drive converter cabinet units
Operating Instructions, 07/07, A5E00288214A