Siemens SINAMICS S150 Operating Instructions Manual page 517

Power Supply, Internal, 57
Preparatory steps
Mechanical installation, 33
Principles
Command data set (CDS), 177
Copy motor data set (MDS), 181
Copying the command data set (CDS), 181
Copying the drive data set (DDS), 181
Drive data set (DDS), 178
Encoder data set (EDS), 179
Interconnecting signals, 183
Motor data set (MDS), 180
PROFIBUS, 200
Bus terminating resistor, 201
Connectors, 201
Setting the PROFIBUS Address, 203
PROFIBUS link, 200
PROFINET IO, 244
Addresses, 246
Device OM, 254
GSDML V1.0, 252
GSDML v2.0, 253
IRT, 255
IRTflex, 256
IRTtop, 257
RT, 252
RT and IRT, 244
RT classes, 250
Protecting power components, 400
Protective functions, 400
PT100 Evaluation Unit (Option L86), 87
Q
Quality, 21
R
Ramp-function generator, 264
Reactive power compensation, 305
Reference mark search, 362
Reference model, 283
Relay outputs, 66
Removing the noise suppression capacitor, 58
Replacement
Automatic firmware update, 472
Control Interface Board, frame size FX, 442
Control Interface Board, frame size GX, 444
Control Interface Board, frame size HX, 446
Control Interface Board, frame size JX, 448
Crane lifting lugs, 429
Drive converter cabinet units
Operating Instructions, 07/07, A5E00288214A
Error messages, 472
Fan in the Active Interface Module (frame size
FI), 460
Fan in the Active Interface Module (frame size
GI), 462
Fan in the Active Interface Module (frame size
HI), 464
Fan in the Active Interface Module (frame size
JI), 466
Fan, frame size FX, 450
Fan, frame size GX, 452
Fan, frame size HX, 454
Fan, frame size JX, 458
Filter mats, 431
Installation device, 428
Operator panel, 469
Operator panel battery, 469
Power block (frame size FX), 432
Power block (frame size GX), 434
Power block (frame size HX), 436
Power block (frame size JX), 440
Replacing components, 431
Replacing the Backup Battery of the Cabinet Operator
Panel, 469
Replacing the cabinet operator panel, 469
Residual risks, 18
Rotating measurement, 311
Runtime, 331
S
S5 – Selector for Voltage/Current AI0, AI1, 65
Saving the Parameters, Permanently, 237
Separate 24 V DC power supply for NAMUR (option
B02), 113
Service, 21
Service and Support, 423
Setpoint addition, 260
Setpoint channel, 260
Setpoint sources, 195
Analog inputs, 195
Fixed speed setpoints, 198
General, 172
Motorized potentiometer, 197
Setting the PROFIBUS Address, 203
Settings for the infeed (Active Infeed) under difficult line
conditions, 306
Shield connection, 60
Signal connections, 60
Simulation operation, 332
Sinusoidal filter (option L15), 69
Slip compensation, 272
Index
517