Siemens SINAMICS S150 Operating Instructions Manual page 413

VSM - Interface Module in the Active Interface Module (-A2)
Table 10-5 Description of the LEDs on the Voltage Sensing Module
LEDs Color
RDY ---
Green
Orange
Red
Green/red
Green/orange
or
red/orange
SMC10 – encoder evaluation (-A83)
Table 10-6 Description of the LEDs on the SMC10
LEDs Color
RDY ---
Green
Orange
Red
Green/red
Green/orange
or
red/orange
Drive converter cabinet units
Operating Instructions, 07/07, A5E00288214A
Status
OFF The electronics power supply is missing or lies outside the permissible
tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-CLiQ
communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
Continuous At least one fault is pending on this component.
Note:
LED is driven irrespective of the corresponding messages being
reconfigured.
0.5 Hz flashing Firmware is being downloaded.
light
2 Hz flashing Firmware download is complete. Wait for POWER ON.
light
2 Hz flashing Detection of the components via LED is activated (p0144).
light Note:
Both options depend on the LED status when module recognition is
activated via p0144 = 1.
Status
OFF The electronics power supply is missing or lies outside the permissible
tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-CLiQ
communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
Continuous At least one fault is pending on this component.
Note:
LED is driven irrespective of the corresponding messages being
reconfigured.
0.5 Hz flashing Firmware is being downloaded.
light
2 Hz flashing Firmware download is complete. Wait for POWER ON.
light
2 Hz flashing Detection of the components via LED is activated (p0144).
light Note:
Both options depend on the LED status when module recognition is
activated via p0144 = 1.
Diagnosis / faults and alarms
Description
Description
10.2 Diagnosis
413