Table of Contents
Advertisement
Chapter 4: Configuring the Emulator
Configuring the Emulator Pod
To specify the analyzer's response to bus
arbitration
• Answer "disable", "enable", or "tag" to the "Arbitration analysis?" question.
When DMA tracing is disabled, the analyzer will not capture any external or
internal DMA, bus cycles.
When DMA tracing is enabled, the analyzer will capture analyzer states during
external or internal DMA bus cycles. The analyzer state can be generated only if
the processor strobes are actually being driven on the external DMA cycle.
When DMA tagging is enabled, a single emulation analyzer state will be generated
each time an external bus arbitration sequence occurs. Processor strobes do not
need to be driven.
129
Advertisement
Table of Contents
