Honda CBR650F Service Manual page 251

dummyhead dummyhead
CRANKCASE/TRANSMISSION
COUNTERSHAFT
THRUST WASHER
NEEDLE BEARING
NEEDLE BEARING
C1 GEAR (43T)
C6 GEAR (34T)
SNAP RING
SPLINE WASHER
C2 GEAR BUSHING
INSTALLATION
Install the mainshaft assembly [1] into the upper
crankcase.
Apply engine oil to the mainshaft bearing [2].
Install the mainshaft bearing [2] into the upper
Install the bearing
crankcase.
into the crankcase
with the marked
side facing out.
13-10
THRUST WASHER
SNAP RING
SPLINE WASHER
C5 GEAR (36T)
C2 GEAR (38T)
COUNTERSHAFT
: Gear teeth
:
C4 GEAR BUSHING
C4 GEAR (38T)
LOCK WASHER
SPLINE WASHER
BEARING SET RING
[2]
Rotating gear inner surface
C2 bushing entire surface
C3, 4 bushing outer surface
C5, C6 gear inner spline surface
C5, C6 gear shifter groove
C1 needle bearing rotating area
C3 GEAR BUSHING
C3 GEAR (32T)
SPLINE WASHER
SNAP RING
OIL SEAL
[1]