Handlebar Switch - Honda CBR650F Service Manual

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
REMOVAL/INSTALLATION
Remove the top bridge (page 16-25).
Remove the protector [1].
Remove the two bolts [2] and ignition switch [3].
• Use a drill or an equivalent tool when removing the
ignition switch mounting bolts.
Installation is in the reverse order of removal.
• Replace the switch bolts with new ones.
• Route the immobilizer receiver wire into the left
groove [4] in the protector.
TORQUE:
Ignition switch mounting bolt:
24 N·m (2.4 kgf·m, 18 lbf·ft)
Install the top bridge (page 16-28).

HANDLEBAR SWITCH

LEFT HANDLEBAR SWITCH
Remove the following:
– Left middle cowl (page 2-10) (CBR650F/FA)
– Left tank shroud A (page 2-10) (CB650F/FA)
Disconnect the left handlebar switch 10P (Gray)
connector [1].
Check for continuity between the switch side 10P
(Gray) connector terminals in each switch position
according to the continuity chart.
– CBR650F/FA (page 23-2)
– CB650F/FA (page 23-3)
21-16
CBR650F/FA shown:
[1]
[4]
[2]
CBR650F/FA:
[1]
CB650F/FA:
[1]
[3]