Starter Clutch - Honda CBR650F Service Manual

dummyhead dummyhead
Install the pressure plate [1].
Install the clutch springs [2] and spring bolts [3].
Tighten the bolts to the specified torque in a crisscross
pattern in two to three steps.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Apply molybdenum oil solution to the starter idle gear
shaft [1] outer surface.
Install the starter idle gear [2] and shaft.
Install the wave washer [1] and thrust washer [2] onto
the starter idle gear.
Install the right crankcase cover (page 11-4).

STARTER CLUTCH

REMOVAL
Remove the clutch (page 11-6).
Remove the starter reduction gear [1] from the
crankcase.
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
[1]
[2]
[1]
[1] [2]
[1]
[2]/[3]
11-13