Honda CBR650F Service Manual page 317

dummyhead dummyhead
REAR WHEEL/SUSPENSION
Remove the shock absorber lower mounting nut [1] and
bolt [2].
Remove the shock absorber [3] out of the frame.
Installation is in the reverse order of removal.
• Turn the drain hole [4] to the lower side.
• The mounting bolt is installed from the right side.
TORQUE:
Shock absorber mounting nut:
44 N·m (4.5 kgf·m, 32 lbf·ft)
DISASSEMBLY/ASSEMBLY
Remove the pivot collar [1] and dust seals [2].
Apply molybdenum disulfide grease to rotating areas of
the needle bearings.
Apply molybdenum disulfide grease to the lips of new
dust seals.
Install each dust seal with the flat side facing out so that
it is flush with the end surface.
Install the pivot collar.
INSPECTION
Inspect the following parts of the shock absorber for
damage, abnormal wear, oil leakage or bend.
– Damper unit
– Pivot bushing
– Needle bearing
BEARING REPLACEMENT
Press the needle bearing out of the shock absorber
using the special tools.
TOOLS:
[1] Driver
[2] Attachment, 22 x 24 mm
[3] Pilot, 17 mm
Apply molybdenum disulfide grease to rotating areas of
a new needle bearing.
Carefully press in the bearing [4] with the marked side
facing up until the depth from the pivot end surface is
5.0 – 5.5 mm (0.20 – 0.22 in), using the same tools.
17-8
[4]
[1]
07949-3710001
07746-0010800
07746-0040400
[3]
[2]
[1]
5.0 – 5.5 mm
(0.20 – 0.22 in)
[1]
[2]
[4]
[3]
[2]