Honda CBR650F Service Manual page 314

dummyhead dummyhead
Installation is in the reverse order of removal.
• When installing the wheel, take care not to let the
caliper bracket [1] come off the swingarm boss [2]
and not to damage the brake pads.
• The axle is installed from the left side.
• CBR650FA/CB650FA: Before installing the rear
wheel speed sensor [3], wipe the sensor tip and
mounting area to remove any foreign material.
Adjust the drive chain slack (page 3-13).
TORQUE:
Rear axle nut: 98 N·m (10.0 kgf·m, 72 lbf·ft)
Check the air gap between the wheel speed sensor and
CBR650FA/
pulser ring (page 19-21).
CB650FA:
INSPECTION
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly. Also
check that the bearing outer race fits tightly in the hub.
Replace the bearings if they do not turn smoothly,
quietly, or if they fit loosely in the hub.
Inspect the following parts for damage, abnormal wear,
deformation or bend.
– Rear axle
– Wheel hub
– Wheel rim
– Driven sprocket (page 3-14)
– Damper rubbers (page 17-6)
Measure each part according to REAR WHEEL/
SUSPENSION SPECIFICATIONS (page 1-9).
Replace any part if it is out of service limit.
REAR WHEEL/SUSPENSION
[2] [1]
[3]
17-5