Honda CBR650F Service Manual page 315

dummyhead dummyhead
REAR WHEEL/SUSPENSION
DISASSEMBLY/ASSEMBLY
Disassemble and assemble the rear wheel as following
illustration.
• For wheel balance service (page 16-17).
• Install the rear wheel dust seal with the flat side
facing out so that it is flush with the wheel hub.
• Install driven flange dust seal with the flat side facing
out so that it is flush with the driven flange end face.
• Install the brake disc with the rotation mark (arrow) facing out.
DISC BOLTS
42 N·m (4.3 kgf·m, 31 lbf·ft)
BRAKE DISC
DUST SEAL
BEARING (6204UU)
BEARING REPLACEMENT
WHEEL BEARING
Install the bearing remover head [1] into the bearing.
From the opposite side of the wheel, install the bearing
remover shaft [2] and drive the bearing out of the wheel
hub.
TOOLS:
Bearing remover head, 20 mm
Bearing remover shaft
Remove the distance collar and drive out the other
bearing.
17-6
PULSER RING
(CBR650FA/CB650FA only)
DRIVEN FLANGE COLLAR
DISTANCE COLLAR
BEARING (6204UU)
07746-0050600
07746-0050100
DRIVEN FLANGE
O-RING
DAMPER RUBBERS
BEARING (63/22)
DUST SEAL
DRIVEN
SPROCKET
SPROCKET NUTS
108 N·m (11.0 kgf·m, 80 lbf·ft)
[1]
[2]