Honda CBR650F Service Manual page 273

dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
Drain the engine oil (page 3-9).
Drain the coolant (page 8-4).
Fully slacken the drive chain (page 3-13).
Remove the following:
– Drive sprocket cover (page 2-16)
– Radiator (page 8-7)
– Exhaust pipe/muffler (page 2-18)
– Throttle body (page 7-13)
– VS sensor (page 4-38)
– Radiator reserve tank (page 8-9)
– ABS modulator cover (page 4-35)
– EVAP canister (page 7-23) (TH model only)
Disconnect the following:
– CKP sensor 2P (Black) connector [1]
– ECT sensor 2P (Blue) connector [2]
– Water bleeding hose [3]
Release the alternator wire clips [1] and remove the
wire out of the frame.
Release the terminal cap [1].
Remove the terminal nut [2] and disconnect the starter
motor cable [3].
Remove the starter motor mounting bolt [4] and
negative (–) cable [5].
Disconnect the neutral switch connector [6].
Remove the bolt [1] and clutch cable holder [2], then
disconnect the clutch cable [3] from the clutch lifter arm
[4].
15-4
[3]
[1] (CBR650F/FA only)
[1]
[2]/[3]
[4] [5]
[3]
[4]
[1]
[2]
[1]
[6]
[2]
[1]