Fuel Tank - Honda CBR650F Service Manual

dummyhead dummyhead
FUEL FLOW INSPECTION
• Check the fuel tank breather hose on the frame for
pinch or clogs when the fuel tank is lifted.
Disconnect the fuel injector side quick connect fitting
(page 7-4).
Place the end of the fuel feed hose [1] into an approved
Wipe off spilled out
gasoline container.
gasoline.
Temporarily connect the fuel pump 3P (Black)
connector and battery negative (–) cable.
Turn the ignition switch ON with engine stop switch " ".
The fuel pump operates for 2 seconds. Repeat 5 times
to meet the total measuring time.
• Return fuel to the fuel tank when the first fuel is
flowed.
Measure the amount of fuel flow.
Amount of fuel flow:
125 cm
10 seconds at 12 V
If fuel flow is less than specified volume, inspect the
following:
– Fuel feed hose for clogs
– Fuel tank breather hose (tank side) for pinch or clogs
– Fuel filter for clogs
– Fuel pump (page 7-8)
Connect the quick connect fitting (page 7-5).

FUEL TANK

REMOVAL/INSTALLATION
Disconnect the quick connect fitting from the fuel tank
(page 7-4).
Release the wire clip [1] from the rear fender B.
Lower the fuel tank, being careful not to pinch the wire
and hoses.
Remove the nut [2], washer [3], bolt [4] and fuel tank [5].
Installation is in the reverse order of removal.
• The mounting bolt is installed from the left side.
TORQUE:
Fuel tank mounting nut: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the quick connect fitting (page 7-5).
3
(4.23 US oz, 4.40 Imp oz) minimum/
[1]
[5]
[4]
[3]
FUEL SYSTEM
[1]
[2]
7-7