Sidestand Switch - Honda CBR650F Service Manual

dummyhead dummyhead

SIDESTAND SWITCH

INSPECTION
Disconnect the sidestand switch 2P (Black) connector
[1].
Check for continuity between the switch side connector
terminals.
There should be continuity with the sidestand retracted,
and, no continuity when the sidestand is lowered.
REMOVAL/INSTALLATION
Remove the drive sprocket cover (page 2-16).
Disconnect the sidestand switch 2P (Black) connector
[1] and remove the sidestand switch wire [2] out of the
frame.
Remove the bolt [1] and sidestand switch [2].
Installation is in the reverse order of removal.
• Align the switch pin with the hole in the sidestand
and the switch groove with the return spring pin.
• Replace the switch bolt with a new one.
TORQUE:
Sidestand switch mounting bolt:
10 N·m (1.0 kgf·m, 7 lbf·ft)
LIGHTS/METERS/SWITCHES
CBR650F/FA shown:
[1]
CBR650F/FA shown:
[1]
[1]
[2]
[2]
Align
Align
21-19