License Light - Honda CBR650F Service Manual

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
BRAKE/TAIL LIGHT
INSPECTION
Turn the ignition switch ON and engine stop switch " ".
Check the brake/tail light operation.
Check that tail light LEDs in the brake/tail light unit illuminate with the ignition switch ON.
Check that brake light LEDs in the brake/tail light unit illuminate with the front brake lever and/or rear brake
pedal applied.
If any LED does not turn on, replace the rear combination light unit.
BRAKE/TAIL LIGHT UNIT REMOVAL/
INSTALLATION
Remove the following:
– Rear fender A (page 2-13)
– Seat (page 2-12)
Disconnect the brake/tail light 3P (White) connector [1].
Remove the two nuts [2], washers [3] and brake/tail
light unit [4].
Installation is in the reverse order of removal.

LICENSE LIGHT

BULB REMOVAL/INSTALLATION
Remove the two tapping screws [1] and license light
lens [2].
Pull the bulb [3] out of the socket without turning it.
Make sure the rubber seal [4] on the license light base
is installed in position and is in good condition, and
replace it with a new one if necessary.
Installation is in the reverse order of removal.
TORQUE:
Tail light lens screw:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
21-6
[3]
[2]
[1]
[3]
[4]
[4]
[2]
[1]