Diagnostic Code Indication - Honda CBR650F Service Manual

dummyhead dummyhead
IMMOBILIZER SYSTEM (HISS)
7. Turn the ignition switch OFF and remove the second key.
• The system will not enter the normal mode unless the two keys are registered in ECM.
• The third new key cannot be continuously registered. When it is necessary to register the third key, follow the procedures "When
the key has been lost, or additional key is required" (page 22-3).
8. Check that the engine can be started using all registered keys.
9. Replace the remaining key set parts.
When the ECM is faulty:
1. Obtain a new ECM and two new transponder keys.
2. Grind the keys in accordance with the shape of the original key.
3. Replace the ECM with a new one (page 4-35).
4. Turn the engine stop switch " " and the ignition switch ON with a first new key. The HISS indicator comes on for two seconds,
then it blinks four times repeatedly.
• The first key is registered in the ECM.
• If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain for approx. ten
seconds, then it will indicate the diagnostic code (page 22-7).
5. Turn the ignition switch OFF and remove the first key.
6. Turn the ignition switch ON with a second new key. The HISS indicator comes on for two seconds, then it blinks four times
repeatedly.
• The second key is registered in the ECM.
• If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain for approx. ten
seconds, then it will indicate the diagnostic code (page 22-7).
7. Turn the ignition switch OFF and remove the second key.
• The system will not enter the normal mode unless the two keys are registered in ECM.
• The third new key cannot be continuously registered. When it is necessary to register the third key, follow the procedures "When
the key has been lost, or additional key is required" (page 22-3).
8. Check that the engine can be started using all registered keys.

DIAGNOSTIC CODE INDICATION

Turn the ignition switch OFF.
Disconnect the CKP sensor 2P (Black) connector [1].
Connect the adaptors to the wire harness side connector.
Connect the Red clip [2] of the adaptor to the 12 V battery positive (+)
terminal and Black clip [3] to the negative (–) terminal.
TOOLS:
[4] Inspection adaptor
[5] Test harness adaptor
Turn the engine stop switch " " and the ignition switch ON with the properly
registered key.
The HISS indicator will come on for approx. ten seconds then it will start
blinking to indicate the diagnostic code if the system is abnormal.
The blinking frequency is repeated.
The HISS indicator remains on when the system is normal (The system is in the normal mode and the diagnostic code does not
appear).
22-6
07XMZ-MBW0101
070MZ-MGE0100
[5]
[4]
[3] [2]
[1]