Drive Chain Slider - Honda CBR650F Service Manual

dummyhead dummyhead
Insert a new master link [1] with new O-rings [2] from
Never reuse the old
the inside of the drive chain, and install a new plate [3]
drive chain, master
and O-rings with the identification mark facing out.
link, master link
plate and O-rings.
Assemble the master link, O-rings and plate.
TOOL:
Drive chain tool set
Make sure that the master link pins [1] are installed
properly.
Measure the master link pin length projected from the
plate.
STANDARD LENGTH: Approx. 1.3 mm (0.05 in)
Stake the master link pins with the drive chain tool set.
Make sure the pins are staked properly by measuring
the diameter of the staked area.
DIAMETER OF STAKED AREA:
DID525V11: 5.50 – 5.80 mm (0.217 – 0.228 in)
RK525KRW: 5.30 – 5.70 mm (0.209 – 0.224 in)
After staking, check the staked area of the master link
for cracks.
If there is any cracking, replace the master link, O-rings
and plate.

DRIVE CHAIN SLIDER

Check the drive chain slider [1] for wear or damage.
The drive chain slider must be replaced if it is worn to
the wear limit lines [2] (page 17-10).
07HMH-MR10103
[1]
[1]
MAINTENANCE
[2]
[1]
[2]
[3]
3-15