Honda CBR650F Service Manual page 129

dummyhead dummyhead
PGM-FI SYSTEM
INSPECTION
SYSTEM INSPECTION WITH MCS
Remove the bank angle sensor without disconnecting
its connector (page 4-39).
Connect the MCS to the DLC (page 4-6).
Check the output voltage at each position of the sensor
with the MCS.
STANDARD:
Horizontal Position: 7.0 – 8.8 V
Approx. 60°: 0.40 – 0.84 V
FUNCTION CHECK
Remove the bank angle sensor without disconnecting
its connector (page 4-39).
Pull out the bank angle sensor from the frame.
Temporarily install the following:
– Air cleaner housing (page 7-12)
– Fuel tank (page 7-7)
Place the bank angle sensor [1] horizontal.
Start the engine.
• Do not crank the engine, when the air cleaner
housing is not installed.
Incline the bank angle sensor approximately 60° to the
left or right.
The bank angle sensor is normal if the engine stops
after a few seconds.
4-40
Inclined Position:
Horizontal
Position:
Approx. 60°
[1]
Approx. 60°