Honda CBR650F Service Manual page 274

dummyhead dummyhead
Release the rubber cap [1] from the EOP switch.
Remove the terminal screw [2] and disconnect the
switch wire [3].
Release the wire clips [4].
Remove the drive sprocket bolt [1], washer [2] and drive
sprocket [3].
Support the motorcycle securely with a hoist or
CBR650F/FA:
equivalent.
Place a floor jack or other adjustable support under the
Do not use the oil
engine.
filter as a jacking
point.
• The jack height must be continually adjusted to
relieve stress for ease of bolt removal.
Remove the following:
– Front engine hanger bolts [1]
– Collar [2] (left side only)
Support the motorcycle securely with a hoist or
CB650F/FA:
equivalent.
Place a floor jack or other adjustable support under the
Do not use the oil
engine.
filter as a jacking
point.
• The jack height must be continually adjusted to
relieve stress for ease of bolt removal.
Disconnect the horn wire connectors [1] and release the
wire clip [2].
Remove the following:
– Left front engine hanger bolt [3]
– Left tank shroud stay assembly [4]
– Collar [5]
– Right front engine hanger bolt [6]
– Right tank shroud stay [7]
ENGINE REMOVAL/INSTALLATION
[1]
[2]
[1]
CBR650F/FA:
[1] [2]
CB650F/FA:
[3]
[7]
[4]
[2]
[5]
[6]
[1]
[4]
[3]
[3]
[2]
[1]
15-5