Fuel Line Inspection - Honda CBR650F Service Manual

dummyhead dummyhead
FUEL SYSTEM

FUEL LINE INSPECTION

FUEL PRESSURE RELIEVING
• Before disconnecting fuel feed hose, relieve
pressure from the system as follows.
1. Turn the ignition switch OFF.
2. Lift the fuel tank and support it (page 3-4).
3. Disconnect the fuel pump 3P (Black) connector [1].
4. Start the engine, and let it idle until the engine stalls.
5. Turn the ignition switch OFF.
QUICK CONNECT FITTING REMOVAL
• Clean around the quick connect fitting before
disconnecting the fuel feed hose, and be sure that
no dirt is allowed to enter into the fuel system.
• Do not bend or twist the fuel feed hose.
1. Relieve the fuel pressure (page 7-4).
2. Disconnect the negative (–) cable from the battery
(page 20-5).
3. Lift the fuel tank and support it (page 3-4).
4. Unlock the slide retainer [1] of the quick connect
fitting [2] by completely pulling it up.
5. Release the quick connect fitting from the joint pipe
[3] while holding the connector housing.
• Prevent the remaining fuel in the fuel feed hose from
flowing out, using a shop towel.
• Be careful not to damage the slide retainer and
hose.
• Do not use tools.
6. To prevent damage and keep foreign matter out,
cover the disconnected connector and pipe end with
the plastic bags [1].
7-4
[1]
[2]
[1]
[3]
[1]