Honda CBR650F Service Manual page 320

dummyhead dummyhead
INSPECTION
Inspect the following parts for damage, abnormal wear,
deformation.
– Swingarm
– Pivot collars
– Bearings
– Drive chain slider (page 3-15)
SWINGARM PIVOT BEARING
REPLACEMENT
RIGHT SIDE
Remove the snap ring [1].
Press the ball bearing [1] and needle bearing [2] out of
the right pivot using the special tools.
TOOLS:
[3] Driver, 15 x 280L
[4] Attachment, 24 x 26 mm
[5] Pilot 20 mm
Apply molybdenum disulfide grease to the rotating area
of a new ball bearing [1].
Install the ball bearing into the right pivot with the
marked side facing out until it is fully seated using a
hydraulic press and special tools as shown.
TOOLS:
[2] Driver
[3] Attachment, 37 mm
[4] Pilot 20 mm
07949-3710001
07746-0010700
07746-0040500
07749-0010000
07ZMD-MBW0200
07746-0040500
REAR WHEEL/SUSPENSION
[3]
[1]
[4]/[5]
[1]
[2]
[2]
[3]/[4]
[1]
17-11