Honda CBR650F Service Manual page 230

dummyhead dummyhead
Install the starter clutch outer assembly [1] to the
crankshaft while aligning the tab of the crankshaft with
the wide groove of the starter clutch outer assembly.
Apply engine oil to the starter clutch outer mounting bolt
[1] threads and seating surface.
Install the washer [2] and starter clutch mounting bolt.
Temporarily install the following:
– Oil pump drive sprocket guide
– Oil pump drive sprocket
– Clutch outer guide
– Clutch outer [1]
– Clutch outer needle bearing
Attach the gear holder [2] between the primary drive
Be careful not to
gear and driven gear.
drop the gear holder
into the crankcase.
TOOL:
[2] Gear holder, M2.5
Tighten the starter clutch outer mounting bolt [3] to the
specified torque.
TORQUE: 83 N·m (8.5 kgf·m, 61 lbf·ft)
Remove the temporarily installed parts.
Apply molybdenum oil solution to the starter reduction
gear [1] sliding surface.
Install the starter reduction gear into the crankcase.
Install the clutch (page 11-9).
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
[1]
07724-0010100
Align
[2]
[1]
[1]
[3]
[2]
[1]
11-17