Honda CBR650F Service Manual page 374

dummyhead dummyhead
FRONT TURN SIGNAL LIGHT UNIT
REMOVAL/INSTALLATION
CBR650F/FA
Open the wire clamp [1] and disconnect the front turn
signal light 3P connector [2] (left: Orange, right: Light
blue).
Release the rubber cap [3].
Remove the following:
– Cap nut [4]
– SettIng plate [5]
Remove the front turn signal light unit [6] by pulling the
wire [7] out from the rubber cap and cowl.
Installation is in the reverse order of removal.
TORQUE:
Front turn signal light mounting nut:
10 N·m (1.0 kgf·m, 7 lbf·ft)
CB650F/FA
Remove the headlight assembly from the bottom bridge
(page 21-3).
Remove the turn signal light mounting screw [1] and
plate [2].
Remove the turn signal light unit [3] by pulling the wire
[4] out from the hole [5] of the mounting rubber.
Installation is in the reverse order of removal.
TORQUE:
Rear turn signal light mounting screw:
2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
REAR TURN SIGNAL LIGHT
REMOVAL/INSTALLATION
Remove the following:
– Rear fender A (page 2-13)
– Seat (page 2-12)
Disconnect the turn signal light 2P connector [1] (left:
Orange, right: Light blue).
Remove the turn signal light mounting screw [2] and
plate [3].
Remove the turn signal light unit [4] by pulling the wire
[5] out from the holes [6] of the rear fender B and
mounting rubber.
Installation is in the reverse order of removal.
TORQUE:
Rear turn signal light mounting screw:
2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
LIGHTS/METERS/SWITCHES
[2]
[1]
[4]
[5]
[3]
[2]
[5]
[3]
[1]
[6]
[7]
[6]
[4]
[1]
[3]
[5]
[4]
[2]
21-5