Honda CBR650F Service Manual page 289

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
Install the front right handlebar switch housing [1] by
aligning the locating pin with the hole in the handlebar.
Install the rear right handlebar switch housing [2].
Tighten the upper screw [3] first, then tighten the lower
screw [4] to the specified torque.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
Install the master cylinder [1] and holder [2] with the
Align the edge of
"UP" mark [3] facing up. Tighten the upper bolt [4] first,
the master cylinder
then the lower bolt [5] to the specified torque.
with the punch
mark on the
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
handlebar.
Connect the brake light switch connectors [6].
Install the left handlebar switch housings [1] by aligning
the locating pin with the hole in the handlebar. Tighten
the upper screw [2] first, then tighten the lower screw [3]
to the specified torque.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
Install the clutch lever bracket [1] and holder [2] with the
Align the edge of
"UP" mark [3] facing up. Tighten the upper bolt [4] first,
the bracket with the
then the lower bolt [5].
punch mark on the
handlebar.
Connect the clutch switch connectors [6].
16-12
Align
[1]
[1]
Align
[6]
[2]
Align
[1]
[2]
Align
[4]
[3]
[5]
[3] [2]
[4]
[2]
[4]
[3]
[5]
[3]
[1]
[6]