Honda CBR650F Service Manual page 379

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
REMOVAL/INSTALLATION
CBR650F/FA:
Remove the meter panel (page 2-9).
Remove the three tapping screws [1], washers [2] and
combination meter [3] from the headlight stay.
Disconnect
connector [4].
Installation is in the reverse order of removal
TORQUE:
Combination meter mounting screw:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
CB650F/FA
Remove the headlight stay assembly (page 2-7).
Remove the three tapping screws [1], washers [2] and
combination meter [3] from the headlight stay.
Disconnect
connector [4].
Installation is in the reverse order of removal
TORQUE:
Combination meter mounting screw:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
DISASSEMBLY/ASSEMBLY
Remove the combination meter assembly.
– CBR650F/FA (page 21-10)
– CB650F/FA (page 21-10)
Remove the eight tapping screws [1].
Remove the following:
– Upper case (lens) [2]
– Combination meter [3]
– Two extension rods [4]
– Under case [5]
Assembly is in the reverse order of disassembly.
• Be sure the rubber seal is installed in the groove
properly.
21-10
the combination meter
the combination meter
CBR650F/FA shown:
[3]
16P (Gray)
[4]
[2]
[1]
[3]
16P (Gray)
[3]
[2]
[4]
[2]
[1]
[5]
[1]
[4]