Brake Pedal - Honda CBR650F Service Manual

dummyhead dummyhead
INSPECTION
Check the following parts for scoring, scratches,
deterioration or damage.
– Caliper cylinder
– Caliper piston
Measure the parts according to HYDRAULIC BRAKE
SPECIFICATIONS (page 1-9) and replace if necessary.

BRAKE PEDAL

REMOVAL/INSTALLATION
Support the right rider footpeg bracket [1] securely and
remove the bracket bolts [2].
Remove the following:
– Switch spring [1]
– Return spring [2]
– Cotter pin [3]
– Joint pin [4]
– Snap ring [5]
– Washer [6]
– Brake pedal [7]
Installation is in the reverse order of removal.
• Apply grease to the pedal pivot sliding area (grease
groove).
• Install the snap ring with the chamfered edge facing
the thrust load side and be certain it is firmly seated
in the groove. Do not reuse the snap ring which
could easily spin in the groove.
• Replace the cotter pin with a new one.
• Install each spring in the direction as shown.
TORQUE:
Rider footpeg bracket bolt:
37 N·m (3.8 kgf·m, 27 lbf·ft)
HYDRAULIC BRAKE
[1]
[7]
[2] [1]
[2]
[5]
[6]
[4]
[3]
18-15