Honda CBR650F Service Manual page 294

dummyhead dummyhead
Drive in a new right side bearing squarely with the
marked side facing up until it is fully seated.
Install the distance collar.
Drive in a new left side bearing squarely with the
marked side facing up until it is fully seated.
TOOLS:
[1] Driver
[2] Attachment, 42 x 47 mm
[3] Pilot, 20 mm
WHEEL BALANCE
• Mount the tire with the arrow mark [1] facing in the
direction of rotation.
• For optimum balance, the tire balance mark [2] (light
mass point: a paint dot on the side wall) must be
located next to the valve stem [3]. Remount the tire if
necessary.
• The wheel balance must be checked when the front
tire is remounted.
• Stick-type balance weights should be used on this
motorcycle. Use genuine Honda balance weights.
– Before
adhesive from the rim thoroughly and clean the
area where new weights are to be placed with
degreasing agent. Take care not to scratch the rim
surface.
– Do not touch the adhesive surface of the weight
with your bare hands when installing.
– The balance weights are always replaced with
new ones whenever they are removed. Do not
reuse them.
Mount the wheel, tire and brake disc assembly on an
inspection stand [1].
Spin the wheel, allow it to stop, and mark the lowest
(heaviest) part of the wheel with chalk.
Do this two or three times to verify the heaviest area.
If the wheel is balanced, it will not stop consistently in
the same position.
To balance the wheel, install the wheel weights [1] on
the highest side of the rim, on the side opposite the
chalk marks. Add just enough weight so the wheel will
no longer stop in the same position when it is spun.
Do not add more than 60 g (2.1 oz) to the wheel.
Press the weights by your hands firmly and make sure
they are not come off the rim.
• The weights are attached to the position at 8 mm
(0.3 in) from the side surface of the rim in the
direction as shown.
• If the weight exceeds 10 g (0.4 oz), install same
amount of the balance weights on the right and left
symmetrical position.
07749-0010000
07746-0010300
07746-0040500
installing the weights, remove
FRONT WHEEL/SUSPENSION/STEERING
[2]
[1]
any
8 mm
(0.3 in)
[1]
[1]
[3]
[2]
[3]
[1]
16-17