Honda CBR650F Service Manual page 344

dummyhead dummyhead
CIRCUIT INSPECTION
INSPECTION AT ABS MODULATOR CONNECTOR
Remove the ABS modulator cover (page 4-35).
Turn the ignition switch OFF.
Disconnecting procedure:
Turn the lock lever [1] to this side while pressing the lock tab [2] to release it.
Be sure the lock lever is turned all the way and disconnect the ABS
modulator 18P (Black) connector [3].
Connecting procedure:
Be sure to seat the lock lever against the wire side of the connector fully.
Connect the ABS modulator 18P (Black) connector by pressing it straight at
the area as shown (arrow) until the lock tab clicks.
Make sure the connector is locked securely.
• Always clean around and keep any foreign material away from the
connector before disconnecting it.
• A faulty ABS is often related to poorly connected or corroded
connections. Check those connections before proceeding.
• In testing at ABS modulator 18P (Black) connector terminals (wire
harness side; except No. 9 and No. 18 terminals), always use the test
probe [1]. Insert the test probe into the connector terminal, then connect
the digital multimeter probe to the test probe.
TOOL:
Test probe
ANTI-LOCK BRAKE SYSTEM (ABS; CBR650FA, CB650FA)
07ZAJ-RDJA110
Disconnect:
Connect:
[2]
[1]
[3]
TERMINAL LAYOUT:
(Terminal side of the wire harness)
[1]
19-7